Electrical Safety; Using An Extension Cable; Assembly And Adjustments - DeWalt DWE1622 Original Instructions Manual

EN GLI SH
i. Quick-release collar (DWE1622K-B5)
j. Guard
k. Coolant bottle
l. Coolant tube
m. Flow regulator
n. LED indicator light
o. Safety chain (fig. 5)
INTENDED USE
Your DWE1622 magnetic drill press has been
designed for drilling holes in steel construction
surfaces. Do not drill into non-ferrous metal.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This drill press is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
• Connect the green/yellow lead to the earth
terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.

Using an Extension Cable

If an extension cable is required, use an approved
extension cable suitable for the power input of this
8
tool (see Technical Data). The minimum conductor
size is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set- ups or when making repairs.
Be sure the switch is in the OFF
position. An accidental start-up can
cause injury.
Installing the Machine (fi g. 2–5)
1. Assemble the feed handle.
2. Mount the drill guard (j).
3. Fit the lubrication system as necessary.
4. Place the machine on a clean, level and solid
surface. Remove any particles that will obstruct
full contact between the magnetic stand and
the mounting surface.
5. Fit and tighten the safety chain (o).
MOUNTING THE FEED HANDLE ASSEMBLY (FIG. 1, 2)
The quick-release feed handle assembly can be
mounted in one simple operation both to the left and
the right of the machine.
1. Screw all three feed handles (f) into the hub (g).
2. Keep the button (p) depressed while inserting
the hub shaft into the hole (q).
3. Release the button.
MOUNTING THE DRILL GUARD (FIG. 3)
1. Hold the guard (j) in front of the tool holder,
aligning the slots in the guard with the holes in
the machine.
2. Fit the screw (r) into the hole (s) located in the
front of the frame.
WARNING: Always use the drill guard.
FITTING THE LUBRICATION SYSTEM (FIG. 1, 4)
The lubrication system can be used for horizontal
drilling applications (the drill being used vertically).
1. With the coolant bottle (k) placed into the
magnetic bracket (e), mount the magnetic
bracket onto the steel strip (t) on either side of
the tool.