Assembly And Operating - Cub Cadet CCU410 Instruction Manual

Instructions for charging the Power Cell are packed with the charger.
WARNING:
the charger.
INSTALLING THE DRIVE UNIT ON AN
ATTACHMENT
WARNING:
Cell from the drive unit before installing
it on the attachment.
1. Pull the locking lever (1) outward
from the locking collar (2). Align the
groove (3) in the locking collar with
the matching key (4) on the end of
the attachment shaft (5) (Fig. 1).
2. Insert the attachment shaft into the
locking collar until the installation
mark (6) meets the locking collar.
NOTE: Make sure the attachment shaft
is fully inserted into the locking collar. If
it is not fully inserted, the electrical
connection will not be made and the
attachment will not function properly.
3. When the attachment shaft is fully
inserted into the locking collar, push
the locking lever back toward the
locking collar to lock the assembly
together (Fig 2).
NOTE: Make sure the locking lever is
fully pressed toward the locking collar.
This is important to ensure the
assembly is properly locked together.

ASSEMBLY AND OPERATING

Read all safety warnings and charging instructions included with
Remove the Power
3
4
6
14
2
5
Fig. 1
Fig. 2
1