Cub Cadet CCU410 Instruction Manual page 15

INSTALLING THE POWER CELL
Once the Power Cell has been fully
charged and you are ready to start
using the attachment, you will have to
install the Power Cell (1) into the drive
unit with Power Cell "TOP" label (2)
facing upward (Fig. 3).
1. Slide the Power Cell into the
matching cavity (3) in the rear of the
upper cowling (4).
NOTE: Make sure you push the Power
Cell fully into the cavity. The locking
latch (5) will click when the Power Cell is
properly installed.
2. Pull outward on the Power Cell to
verify that it is being held in place by
the locking latch.
To remove the Power Cell for recharging
or storage, press the locking latch
toward the Power Cell. While holding
the locking latch toward the Power Cell,
pull the Power Cell out of the tool.
These instructions cover the basic functions relating to installing the Drive Unit on
an attachment and how to insert & remove a Power Cell.
Refer to the Instruction Manual packed with each attachment or accessory for
detailed safety information, assembly and operation of the Drive Unit,
attachments and accessories.
ASSEMBLY AND OPERATING
4
3
15
5
2
Fig. 3
1