Adjustment
11.
Bobbin winder
04.16
11 - 18
Requirement
1. With the bobbin winder switched on, the bobbin winder spindle must engage reliably.
With the bobbin winder switched off, friction wheel 5 must not touch drive wheel 1.
2. The bobbin winder must switch off automatically when the thread level is approximately
1 mm from the edge of the bobbin.
Fig. 11 - 15
Move drive wheel 1 (screws 2) in accordance with requirement 1.
Place a bobbin on the bobbin winder, thread the bobbin and switch on the bobbin winder.
Move stop latch 3 (screws 4) in accordance with requirement 2.
2
1 5
4
1 mm
3