Maintenance And Service; Maintenance: Frequency And Tasks; Maintenance Tasks - Homeowner - Heatilator NEVO3630I-B Owner's Manual

4 4

Maintenance and Service

Any safety screen or guard removed for servicing must be
replaced prior to operating the fi replace.
When properly maintained, your fi replace will give you
many years of trouble-free service. Contact your dealer
to answer questions regarding proper operation, trou-
bleshooting and service for your appliance. Visit www.
heatnglo.com to locate a dealer. We recommend annual
service by a qualifi ed service technician.
A. Maintenance: Frequency and Tasks
Task Frequency
Glass Cleaning Seasonally
Decorative Fronts Annually
Remote Control Seasonally
Venting Seasonally
Gasket Seal and Annually
Glass Inspection
Firebox Annually
Inspection
Control Annually
Compartment &
Firebox Top
Burner Ignition & Annually
Operation
B. Maintenance Tasks - Homeowner
Installation and repair should be done by a qualifi ed service
technician only. The appliance should be inspected before
use and at least annually by a professional service person.
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any of
the listed tasks, please call your dealer for a service ap-
pointment.
More frequent cleaning may be required due to excessive
lint from carpeting, bedding material, et cetera. It is im-
perative that control compartments, burners and circulat-
ing air passageways of the appliance be kept clean. Any
safety screen, guard, or barrier removed for servicing the
appliance must be replaced prior to operating the appli-
ance.
CAUTION! Risk of Burns! The fi replace shall be turned
off and cooled before servicing.
To be completed by
Homeowner
Qualifi ed Service
Technician
Heatilator • NEVO3630I-B, NEVO4236I-B Owner's Manual • 2378-981 Rev. B • 2/16
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, glass cleaner, drop
cloth and a stable work surface.
CAUTION! Handle fi xed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
• DO NOT use razor blades to clean glass
• Prepare a work area large enough to accommodate fi xed
glass assembly and door frame by placing a drop cloth
on a fl at, stable surface.
Note: Fixed glass assembly and gasketing may have res-
idue that can stain carpeting or fl oor surfaces.
• Remove decorative front from fi replace and set aside
on work surface.
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
• Locate the four glass assembly latches at the top and
bottom of the appliance.
• Pull the four (two upper and two lower) glass assembly
latches out of the groove on the glass frame.
4.1.
Latches
(both bottom
and top)
Glass
Assembly
Figure 4.1 Fixed Glass Assembly
See Figure
15