Heat-N-Glo BE-41 Installer's Manual page 27

5. The grate is located in the lower cav-
ity. Remove the screw holding the
grate in place and discard the screw.
6. Position the grate into the cutout in
the refractory. Hook the grate into po-
sition using the tabs on the bottom
of the grate. Make sure the grate is
pulled forward on the refractory (see
Figure 37).
7. Cut shrink wrap and remove from
around the log assembly.
WARNING: REMOVE ALL
!
PACKAGING FROM LOGS.
8. Install embers. See ember placement
instructions for details.
WARNING: USE DIME SIZE
!
PIECES ONLY. DO NOT
COVER PORTS.
9. Carefully position the log set in place
into the fireplace. Pull the log set for-
ward until the log set contacts the log
placement tabs. Center the log set in
the firebox side to side (see Figure
38). (Grate removed for viewing.)
Figure 37
Log Placement Tabs
Figure 38
29