Lcd Display; Battery Installation - Makita BMR100 Instruction Manual

LCD Display:

A. Radio alarm
B. HWS buzzer alarm
C. Scan tuning
D. Band Indicator
E. Low battery indicator
F. Preset stations
G. Sleep and Snooze status
H. Frequency
I. Stereo symbol and Volume
J. Clock
K. Time set
L. PM for clock

Battery Installation

Note:
Keeping back up batteries inside the compartment
prevent stored data in preset memories from being lost.
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
1
2. Remove back up battery compartment cover and
insert 2 fresh UM-3 (AA sizes). Make sure the
batteries are with correct polarity as shown inside the
compartment. Replace the battery cover.
3. BH2433 | BH2420 After back up batteries are inserted,
insert the main battery pack to power radio. The
suitable battery packs for this radio listed as below.
4
1. Battery
compartment
(covering main
2
battery pack and
back up
batteries)
2. Battery
compartment
locker
1. Main battery
compartment
2. Back up battery
compartment
1
1
2
Cluster Battery:
9.6V: 9135 | 9134 | 9122 | PA09 | 9120
12V: 1235 | 1234 | 1222 | PA12 | 1220
14.4V: 1435 | 1434 | 1422 | PA14 | 1420
18V: 1835 | 1834 | 1822 | PA18
Slide Battery:
9.6V: BH9033 | BH9033A | BH9020 | BH9020A
12V: BH1233 | BH1233C | BH1220C
14.4V: BH1433 | BH1420 | BL1430
18V: BL1830
24V: BH2433 | BH2420
The following tables indicate the operating time on a
single charge.
Battery Cartridge•Voltage
9.6V 12V 14.4V
PA09 PA12 PA14
9120 1220 1420
– – –
9122
1222 1422
BH9020
BH1220C BH1420
BH9020A
9134 1234 1434
1435
9135 1235
BL1430
BH9033 BH1233
BH1433
BH9033A BH1233C
* Operating time may differ by the type of battery, charging or
operating conditions.
3-1. Installing or removing Slide battery cartridge
1
2
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
• To remove the battery cartridge, withdraw it from the
tool while sliding the button on the front of the cartridge
or pressing the buttons on both sides of the cartridge.
Operating time*
(At Max. Volume)
18V 24V
PA18 – Approx. 7 hour
BL1815 – Approx. 8 hour
1822 BH2420 Approx. 11 hour
1834 – Approx. 13 hour
1835
– Approx. 16 hour
BL1830
– BH2433 Approx. 17 hour
1. Button
3
2. Battery cartridge
3. Red part