Atomik WHIPLASH Instruction Manual page 5

ESC SETUP
ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP ESC SETUP
The water-cooled Atomik™ 50A Pro Marine Brushless Speed Control that came in your Atomik™ Whiplash
24" P1 RTR Electric Boat is pre-programmed from the factory. If you need to re-program it, please follow the
instructions below.
FEATURES
• Linear and smooth throttle response.
• Supports multi-pole and high KV brushless motors, perfect low speed control, and auto-detect
motor timing.
• Low voltage cutoff (LVC) to avoid over-discharge of battery and thermo protection to prevent ESC
from overheating.
• Simple to use, brake mode is easily programmable.
• High quality MOS-FET, low resistance, high efficiency, less heat and more durable.
• Waterproof plastic case.
SPECIFICATIONS
Atomik™ 50A Pro Marine
Brushless Speed Control
Continuous Current: 50A
Burst Current (10S): 60A
BEC Mode: Switch
BEC Output: 2A/5V
Battery Cells: LiPO: 2-4
Weight: 1.27 oz (36 g)
Water-Cooling Pipe Dia: 5mm
Size L*W*H*: 46 x 27 x 16 mm
MOTOR RPM LIMIT
2 pole(240,000rpm), 4 pole(120,000rpm), 6 pole(80,000rpm)
8 pole(60,000rpm), 12 pole(40,000rpm), 14 pole(34,000rpm)
PROTECTION FEATURES
• Thermo protection will shut ESC down if temperature reaches above 120˚ C.
• Low Voltage Cutoff (LVC) auto detects at 3V per Cell.
TOGGLE BRAKE/NON-BRAKE MODE
1) Connect motor and receiver to the ESC.
2) Set the trigger to max throttle then turn on the transmitter.
3) Plug in battery to ESC.
4) After 4 high pitched tones, set the trigger to minimum throttle.
5) After 3 repeat monotones, disconnect battery from ESC.
6) Now the braking is turned on. To change brake setting again, repeat above procedures.
1 8 000
4
ATOMIK-RC.COM