Never leave batteries unattended while charging. If you are unsure of how to charge this battery, please contact Atomik™ or seek the advice of your local hobby shop. Never let children charge batteries without adult supervision.
GENERAL GUIDELINES While the Atomik™ P1 36" RTR Electric Boat is incredibly fun, it is not a toy. It is very important that you read and follow the steps detailed in this instruction and radio manual. Failure to follow the guidelines detailed in these manuals could result in damage to property, permanent damage to your model, or personal injury.
ESC SETUP NOTE: The water-cooled Atomik™ 60A Pro Marine Brushless Speed Control that came in your Atomik™ P1 36” RTR Electric Boat is pre-programmed from the factory for use with a LiPO battery. If you need to re-program your ESC, please follow the instructions below.
Do not allow the battery pack temperatures to exceed 120º F/ 52º C while in use. Select a higher low voltage cut-off setting to help reduce the temperature of the battery packs. It is OK to use “NO PROTECTION” when using NiCD or NiMH battery packs. ATOMIK-RC.COM 1 8 002...
** IMPORTANT ** Use medium strength (blue) thread lock on all set screws after adjustments have been made. Allow proper setup/dry time before next use. NOTE: The gap can be easily measured by using a dime / coin to gauge the distance. ATOMIK-RC.COM 1 8 002...
Bow Up Bow Up NOTE: Adjusting the drive strut will effect the drive dog gap. Neutral Neutral Always check the drive dog gap after adjusting the drive shaft angle. Bow down Bow down ATOMIK-RC.COM 1 8 002...
Atomik™ warrants this product to be free of material and workmanship defects when new. If a component is defective or was not correctly made, Atomik™ will, at its sole discretion, repair or replace it free of charge within 90 days from date of purchase.