Related Manuals for Atomik 18
Summary of Contents for Atomik 18
- Page 1 34” C1 RTR Brushless RACING BOAT INSTRUCTION MANUAL AND TUNING GUIDE READY-TO-RUN atomik-rc www. .com...
-
Page 2: Safety Precautions
Never leave battery unattended while charging. If you are unsure of how to charge this battery, please contact Atomik™ or seek the advice of your local hobby shop. Never let children charge batteries without adult supervision. -
Page 3: Table Of Contents
GENERAL GUIDELINES While the Atomik™ C1 34” RTR Electric Boat is incredibly fun, it is not a toy. It is very important that you read and follow the steps detailed in this instruction and radio manual. Failure to follow the guidelines detailed in these manuals could result in damage to property, permanent damage to your model, or personal injury. -
Page 4: Required Items
ESC SETUP NOTE: The two water-cooled Atomik™ 60A Pro Marine Brushless Speed Controls that came in your Atomik™ C1 34” RTR Electric Boat are pre-programmed from the factory for LiPO battery use. If you need to re-program them, please follow the instructions below. - Page 5 Cutoff Timing 0º 3.75º 7.5º 11.25º 15º 18.75º 22.5º 26.25º Shaded Fields are Factory Settings (Recommended). CAUTION: LOW VOLTAGE CUT-OFF Do not use “NO PROTECTION” when using LiPO battery packs. Monitor the battery pack temperatures after each run. Do not allow the battery pack temperatures to exceed 120º F/ 52º C while in use. Select a higher low voltage cut-off setting to help reduce the temperature of the battery packs.
-
Page 6: Batteries
Never leave battery unattended while charging. If you are unsure of how to charge this battery, please contact Atomik™ or seek the advice of your local hobby shop. Never let children charge batteries without adult supervision. -
Page 7: Propeller Install
INSTALLING THE PROPS INSTALLING THE PROPS The Atomik™ C1 34” RTR Electric Boat operates using counter-rotating drives to cancel the torque effect of the props. Because of this, it is extremely important to make sure that you install the correct prop on the correct shaft always noting the correct rotational direction. -
Page 8: Hatch Install
NOTE: To avoid flipping the boat, reduce the throttle to slow the boat while turning. Use the steering dual rate to adjust the steering sensitivity. Refer to the radio manual that came with your kit for complete instructions. ATOMIK-RC.COM C OP YR IGHT © 2 0 1 3 AT OM I K RC... -
Page 9: Tuning Guide
NOTE: Adjusting the drive strut will effect the drive dog gap. Always check the drive dog gap after adjusting the drive shaft angle. ATOMIK-RC.COM 1 8 001... -
Page 10: Pre Run Checklist
ATOMIK-RC.COM C OP YR IGHT © 2 0 1 3 AT OM I K RC... -
Page 11: Maintenance
Atomik High Torque Metal Gear Servo 8186 VR3S 3-Channel 2.4Ghz Transmitter/Receiver 1825A High Torque MG Servo Arms 8188 Atomik 2.4 GHZ 3 Channel Micro FHSS Receiver 1883 Rubber Push Rod Seals 10088 Nylon Lock Nut - Prop (6pcs) 1885 Alloy Antenna Holder... -
Page 12: Trouble Shooting
The information in this manual is distributed on an “As Is” basis, without warranty. While every precaution has been taken in the preparation of the manual, Atomik™ does not have any liability to any person or entity with respect to any loss or damage caused or alleged to be caused directly or indirectly by the information contained in this manual or by the products described in it. -
Page 13: Setup Notes
SETUP NOTES SETUP NOTES ATOMIK-RC.COM 1 8 001... - Page 14 SETUP NOTES SETUP NOTES BATTERY BOAT WEIGHT AND SETUP SPECS CG R ATOMIK-RC.COM C OP YR IGHT © 2 0 1 3 AT OM I K RC...
- Page 15 MOTOR & ESC SERVO PROPS & DRIVE ANGLES CG RANGE 210-230mm ATOMIK-RC.COM 1 8 001...
-
Page 16: Contact Info
Atomik RC™ Australia Customer Service 14028 N. Ohio Street PO Box 7325 For Customer Service issues and the quickest warranty service Rathdrum, Idaho 83858 USA Alexandria, NSW 2015 please visit www.atomik-rc.com © Copyright 2013 Atomik RC 18001 atomik-rc www. .com 0-14...