Toshiba RAS-M10GDV-E Service Manual page 40

Toshiba ilmalämpöpumput myy, huoltaa ja asentaa: Jäähdytinpalvelu RefGroup Oy.
10-1-5. Installation Steps
Drain hose
Fig. 10-1-1
Terminal cover
E cover
E box
Insulated pipe
2
Mounting screw
3
Fig. 10-1-2
1) Unfasten a set screw on the side of the indoor unit. Hook the drain hose holder
together with the fitting. Make sure the drain hose is free from a trap, sag, etc. near the drain hose holder
2) The joint for the drain hose port packaged with the indoor unit should be connected with the insulated
‚
pipe .
3) Insert the pipe snugly into the drain hose port of the drain-up kit
(as deep into the port as the O-ring of the drain hose reaches the groove of the drain hose port)
4) Using two setscrews
5) Remove a set screw and Terminal cover. And remove two set screws on E cover.
6) Remove two set screws fixed E bix at the terminal side. So remove E cover while moving E box up.
7) Remove the short pin connector (2P , blue, CN07) in E box.
8) The float switch connector (2P , blue, CN07) and the drain pump connector (3P , red, CN06) in E box should
be connected with the others on the board and near the filter appropriately.
9) Put each leads from the drain up kit in the upper holder of E box as indicated in the figure.
10) Fix E box, E cover and Terminal cover by each screws appropriately, as it was before.
Drain hose holder
7
Drain-up
1
kit body
ƒ
, secure the drain-up kit
www.ilmalämpöpumput.com
Drain hose
O-ring
Short pin connector
(2P, blue)

.

to the indoor unit.
– 40 –
Drain hose port Convex part
Insulated pipe
2
Fig. 10-1-3
Drain pump connector
(3P, red)
Float switch connector
(2P, blue)
Fig. 10-1-4
‡
to the screw and fasten it
‡
.