Unpacking The Logos Anatta - Goldmund Logos Anatta User Manual

4 UNPACKING & INSTALLATION
•
Stand the speaker up, the arrows on the box's sides show the direction.
•
Open the wood box and remove the top white protection foam (1).
•
Using a palette truck, pull the speaker out of the box and position it to the final
location.
•
Remove all protection foam; be careful to leave on place the last protection block (5).
This block will be removed at the end.
•
Using straps, raise the speaker using the holes under the speaker (2) while a person
removes the palette support (3) (five people at least are needed to make this
operation) and place the speaker at the final location (4).
•
Loose a bit the lateral fixation wheels to create some space, without removing them
completely.
•
Remove the last white protection block (5).
•
Tighten again the lateral fixation wheels. The LOGOS ANATTA is ready to be
connected.
GOLDMUND LOGOS ANATTA Active Speaker - 7