Wiring Directions - wattstopper CX-105 Installation Instructions Manual

WIRING DIRECTIONS

Each WattStopper BZ series power pack can supply power for up to 14 CX-105
sensors.
When using more sensors than this, multiple power packs are required.
REFER TO THE WIRING DIAGRAMS ON THE NEXT PAGE FOR THE FOLLOWING
PROCEDURE:
Connect the low voltage:
• RED wire (+24VDC) from power pack to RED wire on sensor.
• BLACK wire from power pack to BLACK wire on sensor (Control Return) .
• BLUE wire from power pack to BLUE wire on sensor (Control Output 24VDC).
CAUTION
Turn power off at the circuit breaker
before installing power packs or sensors.
www.wattstopper.com