The "How To" Of Programming - Multi-Link Stick Online Manual

Now that you've gotten everything hooked up and in place, the fun
begins! We advise that you read through this section once or twice for
familiarity with the process. You may also want to refer back to the
Programming and Quick Reference Guide
programming values for each feature you wish to control.
The first thing you should do is place a local call to your best buddy. Ask
him or her to lay their phone receiver down for a moment.... but don't
hang it up. This will keep you from incurring any long distance phone
charges or "freaking out" the local phone company with all the numbers
you will dial to program The Stick.
After placing a call to your friend, wait at least five seconds before
proceeding. First, DIAL "# # 7 7" on your telephone key pad. The LED
light will begin blinking rapidly. Immediately listen for three rapid high-
pitch beeps in your handset. Three high-pitch tones indicate that
table to pencil in selected
9
you have entered the programming mode and may "PROCEED".
At this time, you should enter the
wish to program and proper value(s). If the proper register number and
programming value(s) are entered, The Stick will answer with a high-
pitch tone immediately followed by a mid-pitch tone. It kind of sounds
like "bee-blip". This means "OK".
If the numbers you enter are invalid (either for the Feature Register or
program value), The Stick will respond with a single low-pitch
"ERROR" tone. This tone might remind you of the sound you hear when
you "blow it" on your favorite video game.
In either case, three rapid high-pitch tones will immediately follow telling
you to "PROCEED". At this time you may either access and program a
new feature register or correct the previous attempt by entering new numbers.
Register Number of the feature you