Mitsubishi Electric SEZ-A12AR Operation Manual page 4

2. Operation
A
˚C
TEMP.
1
TIMER SET
˚C
TEMP.
TIMER SET
B A
˚C
TEMP.
ON/OFF
TIMER SET
2 1
A
D
˚C
TEMP.
1
TIMER SET
3
4
˚C
ON/OFF
FILTER
CHECK TEST
A
˚C
ON/OFF
FILTER
CHECK TEST
1
ON
˚C
ON
FILTER
CHECK TEST
B C
ON OFF ˚C
ON/OFF
FILTER
CHECK TEST
2
2.4. Selecting a temperature
s s s s s To decrease the room temperature:
1 Press button to set the desired temperature.
AThe selected temperature is displayed.
• Each time you press the button, the temperature value decreases by 1 °C.
s s s s s To increase the room temperature:
1 Press button to set the desired temperature.
AThe selected temperature is displayed.
• Each time you press the button, the temperature value increases by 1 °C.
• Available temperature ranges are as follows:
Cooling & Drying:
Heating:
Automatic:
• The display flashes either 8 °C - 39 °C to inform you if the room tem-
perature is lower or higher than the displayed temperature.
2.5. Selecting a fan speed
1 Press
button to select a desired fan speed.
• Each time you press the button, available options change with the dis-
play A on the remote controller, as shown below.
Fan speed
2-stage
The display and the fan speed of the unit will differ in the following situa-
tions:
• When STAND BY and DEFROST are displayed.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature set-
ting of the unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed
operation. Switching of fan speed is impossible.
2.6. Using the timer
1) Set the current time
button to display the "CLOCK" B.
1 Press
OFF
Remote
controller display A
2 Each time you press
one minute. Each time you press
OFF
increments of one minute.
• Press and hold the button to rapidly change the time.
• The time changes in increments of one minute → ten minutes → in units
of hour; in this order.
• Approximately ten seconds after pressing the button, the display on the
remote controller will turn off.
The example shows a timer set for operation start at 8:00 and end at 17:00.
2) Set the mode to continuous as follows
button to display D
1 Press
3) Set the time to start the unit as follows
button to display B
2 Press
3 Press button to set the time that you want the unit to start.
TIMER SET
The start time is displayed at A.
4) Set the time to stop the unit as follows
button to display C
2 Press
3 Press button to set the time that you want the unit to stop.
TIMER SET
The stop time is displayed at A.
5) Set the mode to timer as follows
button to display D
1 Press
TEMP.
19 - 30 °C
17 - 28 °C
19 - 28 °C
Remote controller display
Low High
M
CLOCK → → → No Display
ON OFF
CLOCK CLOCK
↑
button, the time increases in increments of
button, the time decreases in
.
ON
.
OFF
.
.