Table of Contents
Advertisement
Available languages
Available languages
Basic Operation
Power
You can use all the functions on the panel of the
unit or the remote control after connecting to power
supply (called Standby Mode).
Turning the System On
Press the
button to turn the system on from
standby mode.
Note:
When turning the system on, the system will con-
tinue in the mode it was in when it was turned off
last time.
Turning the System Off
Press the
button again to turn the system off
and go to standby mode.
Note:
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended
period of time.
Select the Correct TV System
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TV in your country.
1
No disc mode, press the SETUP button.
2
Select [Preference Page].
3
Select [TV Type] and then press the
4
Select a setting and then press the ENTER
button.
-
[PAL] - For TV with PAL color system.
-
[Auto] - For TV that is compatible with both
NTSC and PAL (multi-system).
-
[NTSC] - For TV with NTSC color system.
5
To exit the menu, press the SETUP button.
Change System Menu Language
1
Press the SETUP button.
2
Select [General Setup Page].
3
Select [OSD language] and then press the
button.
4
Select a setting and then press the ENTER
button.
5
To exit the menu, press the SETUP button .
Set the Clock
The built-in clock shows the correct time in the
display.
1
In standby mode, press and hold the CLOCK
button to activate the clock setting mode, hour
indicator will blink.
2
Set the hour with the
3
Press the ENTER or CLOCK button to confirm,
minute indicator will blink.
4
Set the minute with the
5
Press the ENTER or CLOCK button to confirm,
28
button.
button or
button.
button or
button.
the built-in clock starts operating and the seconds
start counting from 0.
Note:
*
The operating time of every step shouldn't be
longer than 15 seconds or it will return to the
original display.
*
If there is a power failure or the power system is
turned off, the clock will lose its setting.
*
In standby mode, press and hold the CLOCK
button for some seconds, then press the BF
button to select 12/24 hour format.
To confirm the clock time
When you press the CLOCK button, the clock time
is displayed. Wait for a few seconds until the display
returns to the original display.
Adjust Volume Level
During play, press the VOL+/- buttons to
increase/decrease the volume level.
Select a Preset Sound Effect
During play, press the EQ button repeatedly to
select:
-
[POP]
-
[CLASSIC]
-
[ROCK]
-
[JAZZ]
-
[FLAT]
Super Bass Boost
Press the BASS button repeatedly to select the
base boost level.
Mute Sound
During play, press the MUTE
or restore sound. Press this button again or
VOLUME+ button to cancel the effect.
Adjust Brightness of Display Panel
Press the DIM button repeatedly to select differ-
ent levels of brightness for the display panel.
button to mute
Multimedia soundbar
Advertisement
Chapters
Table of Contents
