Listing And Code Approvals; Insert Certification; Btu & Efficiency Specifications; Mobile Home Approved - Quadra-Fire 41I-ACC Owner's Manual

1

Listing and Code Approvals

A. Insert Certification
Model:
4100-I (ACC) Insert
Laboratory: Intertek
Report No:
100428837PRT-001
Type:
Solid Fuel Type, Listed Room Heater
Standard:
UL1482 and ULC S628-93 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S628-93 and
CAN/CSA-B365 Installation Codes in Canada.
B. BTU & Efficiency Specifications
EPA Certified:
Efficiency:
EPA BTU Output:
Heating Capacity:
Vent Size:
Firebox Size:
Max Wood Length:
Max First Hour BTUs:
Fuel:
Shipping Weight:
The Quadra-Fire 4100 Wood Insert (ACC) meets the U.S. Environ-
mental Protection Agency's 1990 particulate emission standards.
C. Mobile Home Approved
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
• The structural integrity of the mobile home floor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
chimney must be listed to UL103 HT or a listed UL-
1777 full length six inch (152mm) diameter liner must
be used.
• Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
October 22, 2013
4.3 grams per hour
up to 80.2%
11,700 to 25,900
up to 1,800 sq ft depending
on climate zone
6 inches
2.43 cubic feet
19.5 inches
67,000 @ 76.8% B415
Tested Efficiency
Cord Wood
345 lbs
D. Glass Specifications
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfire - If appliance or chimney connector glows,
you are overfiring.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
7045-909
WARNING
41I-ACC
7