Sony Trinitron PVM-14M2MDJ Instructions For Use Manual page 32

Using On-Screen Menus
!¶ SPLIT PHASE menu
When the SPLIT function is activated, if the lower side
picture (the signal fed through the RGB/COMPONENT
B input connectors) has some discrepancy of location
with the upper side picture, adjust the SPLIT PHASE
menu.
Each time you press the >(+) button, the lower side
picture moves left.
Note
When the adjustment is made in the menu, the skew
error will occur on the top of the lower side picture.
!• COMPONENT LEVEL menu
Select the component level from among three modes.
N10/SMPTE: for 100/0/100/0 signal
BETA 7.5: for 100/7.5/75/7.5 signal
BETA 0: for 100/0/75/0 signal
For PVM-20M2MDE/20M2MDA/14M2MDE/
14M2MDA
For PVM-20M2MDU/14M2MDU
!ª NTSC SETUP LEVEL menu
Select the NTSC setup level from two modes. The 7.5
setup level is mainly used in north America. The 0 setup
level is mainly used in Japan.
For PVM-20M2MDE/20M2MDA/14M2MDE/
14M2MDA
For PVM-20M2MDU/14M2MDU
@º SUB CONTROL screen
You can finely adjust the controls on the front panel.
CONTRAST, PHASE, CHROMA and BRIGHT
controls have clicks at the center of their adjustment
range. You can adjust the setting of the click position
with this feature.
@¡ V HOLD screen
Adjust the vertical hold if the picture rolls vertically.
Note
If the rolling of the picture prevents you from watching
the screen, select an input that has nothing connected.
32
[MIN]
[N10/SMPTE]
[BETA 0]
[0]
[7.5]