Table of Contents
Advertisement
INSTALLATION
Continued
Blower
Control
Shield
Switch
Plate
Screw
Figure 17 - Installing Switch Plate to
Blower Control Shield
For Built-In Installation
WARNING: A licensed electri-
cian must connect the wiring har-
ness to electrical supply following
all local codes. Electrician must
provide a clamp on the box cover to
secure the wiring. Wiring should be
routed through the bushing in the
hole on the outer casing of heater.
1. Install a snap bushing found in hard-
ware kit into one of the holes found rear
of blower control shield. The other hole
is for a strain relief clamp (not supplied)
to secure incoming electrical supply.
2. Follow steps 2 through 6 in Installing
Blower Assembly, page 10. Also re-
move black wire from middle/OFF
switch terminal.
3.
Remove black plastic strain relief and
power cord from switch plate (see Fig-
ure 18). The power cord supplied will
not be used in built-in installations. Pop
in the plastic snap bushing found in
hardware kit into the hole left by sup-
ply cord/strain relief.
4. A licensed electrician must follow the
wiring diagram in Figure 19 to connect
incoming electrical supply to fan kit
wiring harness.
5. Test to make sure the blower is work-
ing properly.
6.
Reinstall hood assembly (see page 9)
and close lower louver door.
7. Place log set back on the unit.
107188
Screw
Switch
Strain
Relief
Red
Blue
Switch
Plate
Blower
Control
Shield
Clamp Connector
(not included)
Figure 18 - Installing Blower Bracket Assembly
Fan Switch
(Auto/Off/On)
1
2
Off
3
On
110/115
V.A.C.
Black
Red
Green
White
Figure 19 - Wiring Diagram For Fan Accessory Built-In Installation
11
OWNER'S MANUAL
Blower Bracket
Assembly
Wire
Harness
Power
Cord
Outlet
Receptacle
Shield
Cover
Wire
Harness
Auto
Thermostat
Blue
Switch
(N.O.)
Blue
Red
White
Green
For more information, visit www.desatech.com
Blower
Motor
Continued
Advertisement
Table of Contents
