THUNDER TIGER RAPTOR 30 Assembly And Maintenance Manual page 16

16 Servo Installation-Part1
Assembly Tip: Remove all the servo wheels prior to attaching the steel linkage
balls. Make sure all linkages are the correct length.
(1) HSE2612N Self Tapping Screw(M2.6x12)....12
(2) HMF2-8N Screw(M2x8)................................. 4
(3) HML2 Hex Nut(M2)....................................... 4
(4) HME4-5B Set Screw(M4x5).......................... 2
(5) BK0093 Linkage Rod.................................... 2
(6) BK0094 Linkage Rod..................................... 1
(7) BK0100-1 Linkage Rod................................. 1
(8) BK0105 Tail Control Rod Joint....................... 1
(9) BK0075 Linkage Ball..................................... 4
(10) BK0086 Ball Link......................................... 7
Mount the Steel Linkage Balls at
10.5mm(approx 7/16") from the center of
the servo horn.
(4) HME4-5B
(8) BK0105
(7) BK0100-1
86mm
FUTABA
(10) BK0086
(6) BK0094
(10) BK0086
(1) HSE2612N
Before installing Aileron Servo, tape the
wire as shown.
(1) HSE2612N
(2) HMF2-8N
14
73mm
(9) BK0086
(5) BK0093
(2) HMF2-8N
(1) HSE2612N
Aileron Servo
Elevator Servo
(1) HSE2612N
Rudder Servo
(1) HSE2612N
(9) BK0075