Download Print this page
THUNDER TIGER Bandit 3.5 II Assembly Manual

THUNDER TIGER Bandit 3.5 II Assembly Manual

Advertisement

Quick Links

START/FINISH
10M
20M
30M
20M
Tunnel Hull Class 3.5cc
MEMO
12
30M
Assembly Manual
No.5210
Specifications:
Length: 33 3/8" (848mm)
Beam: 11 1/2" (293mm)
Weight: 68.8oz. (1950g)
TTPRO-21M-OB Recommended
This kit is guaranteed to be free from defects in material and workmanship at the date of purchase.
It does not cover any damage caused by use or modification. The warranty does not extend
beyond the product itself and is limited only to the original cost of the kit. By the act of building this
user-assembled kit, the user accepts all resulting in liability for damage caused by the final
product. If the buyer is not prepared to accept this liability, it can be returned new and unused to
the place of purchase for a refund.
This is not a toy. Assembly and running this product requires adult supervision.
Read through this book completely and become familiar with the assembly of this boat. Inspect all
parts for completeness and damage.
customer service if you encounter any problems.
Warranty
Notice: Adult Supervision Required
Browse www.thundertiger.com for more information or
1
JJ6092

Advertisement

loading
Need help?

Need help?

Do you have a question about the Bandit 3.5 II and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for THUNDER TIGER Bandit 3.5 II

  • Page 1 Assembly Manual START/FINISH Tunnel Hull Class 3.5cc No.5210 Specifications: MEMO Length: 33 3/8" (848mm) Beam: 11 1/2" (293mm) Weight: 68.8oz. (1950g) TTPRO-21M-OB Recommended Warranty This kit is guaranteed to be free from defects in material and workmanship at the date of purchase. It does not cover any damage caused by use or modification.
  • Page 2 . Individual Item However, we suggest a Pistol Please contact Thunder Tiger authorized distributor for tech support and customer service if you encounter any Type radio gear is highly Glow Starter-Thunder Tiger problem in assembly or running.
  • Page 3: Parts Listing

    PARTS LISTING PARTS DRAWINGS PJ6212G Tunnel Hull (Green) PJ6212O (Orange) PJ6212Y (Yellow) Hull (1) PJ6213 Display Stand Stand (1) PJ6214G FRP Upper Deck PJ6215 Radio Box PJ6214O PJ6214Y 2.3x12mm Washer Upper Deck (1) Radio Box(1) Wood Screw (4) PJ6219 Hardware PJ6079 Waterproof Set 3169 EZ Connector Switch Plate (1)
  • Page 4 8. Thread the clevis onto the wire and snap to the apply CA glue around the seal and secure it in place. to fit Thunder Tiger outboard marine engine. Apply outboard engine steering arm. Adjust the clevis and epoxy in the hole then secure the engine with four make sure the engine is centered.
  • Page 5 150x50x10(mm) 12. Install the switch with the switch boot. 14. Seal the radio box cover with mask tape as shown. 20. Choose and apply the desired racing no. as shown. 150mm 17.Use hobby knife to cut a piece of foam ( d i m e n s i o n L x W x H : 1 5 0 x 5 0 x 1 0 m m ) f r o m t h e protection insert.
  • Page 6 MAINTENANCE THRUST ANGLE RADIO BOX The default setting of the thrust angle is in the neutral Check Radio box immediately once flipping is occurred. position. However, it might be necessary to adjust if Always keep radio box open after running to absorb Barrel Closed you meet the following situation.