Installation - AEG A72710GNW0 User Manual

Hide thumbs Also See for A72710GNW0:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The temperature in
the freezer is too
warm.
The appliance does
not operate.
The lamp does not
work.
Door interferes with
ventilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.
7.1 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
Food is too near to each
other.
Large quantities of food
to be frozen were put in
at the same time.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is defective.
The door has been open
to long.
The appliance is not lev-
elled.
The appliance is not lev-
elled.
3.
Cli-
mate
class
SN
N
ST
T
Solution
Store food so that there is
cold air circulation.
Insert smaller quantities of
food to be frozen at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect another electrical
appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
Refer to "Replacing the
lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH
33

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

A72710gnx0

Table of Contents