Table of Contents
Advertisement
OPERATION
4. Set the controls the same as for
normal starting (p. 53 – 54,
56 – 58).
Turn the ignition switch key to the
ON position.
KNOT
ALTERNATOR
PULLEY
EMERGENCY STARTER ROPE
5. Set the alternator pulley so the
cutouts are on the right and left
sides of the alternator pulley as
shown. Hook the knot at the end of
the starter rope (accessory) against
a cutout in the alternator pulley,
and wind the starter rope one and a
half turns clockwise along the
groove in the alternator pulley.
60
Direction
to pull
EMERGENCY STARTER ROPE
6. Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and pull
again. If the engine does not start
after several attempts, refer to
TAKING CARE OF UNEXPECTED
PROBLEMS from p. 109.
Exposed moving parts can cause
injury.
• Do not operate the outboard
motor without the engine
cover.
• Use extreme care when
installing the engine cover.
Advertisement
Table of Contents
