Presetting Stations Manually - Yamaha R-S201 Owner's Manual

1
Press FM to select TUNER as the input
source.
2
Press MENU to enter the Option menu.
The Option menu for TUNER is displayed (see
page 19).
3
Press B / C to select "AUTO PRESET", and
then press ENTER.
This unit starts scanning the FM band about
3 seconds later from the lowest frequency upwards.
y
• Before scanning begins, you can specify the first preset
number to be used by pressing PRESET j / i or B/C.
• To cancel scanning, press D.
Preset number
When a station to preset is found, information is
displayed on the front panel display as shown in the
illustration above.
When scanning is complete, "FINISH" is displayed,
and then the display returns to the Option menu.
To return the display to the original state, press
MENU.

■ Presetting stations manually

You can manually register the desired radio stations.
1
2
3
Frequency
4
y
• To cancel registration, switch input or band or do not perform
• You can also preset stations manually by pressing buttons on
MEMORY
PRESET j / i
Tune in to the desired FM/AM station.
See page 14 for tuning instructions.
Press MEMORY.
"MANUAL PRESET" is displayed briefly on the
front panel display, and then the preset number to
which the station will be registered is displayed.
y
By holding down MEMORY for more than 2 seconds, you
can skip the following steps and automatically register the
selected station to an empty preset number (i.e., the preset
number following the last preset number used).
Press PRESET j / i to select the preset
number to which the station will be
registered.
When you select a preset number to which no station
is registered, "EMPTY" is displayed. When you
select a preset number to which a station has already
been registered, the frequency of the station is
displayed.
Preset number
Press MEMORY.
When registration is complete, the display returns to
the original state.
any operations for about 30 seconds.
the front panel with the same names as remote control .
FM/AM TUNING
15
En