Set Up; Inserting Or Replacing Batteries - Liquid Image Explorer Series User Manual

3.0 CAMERA MASK SET UP
CAUTION: An adult 18 years or older should perform this function. Always
make sure the CAMERA MASK is completely dry before performing these
steps. Set up should always take place in a clean dry space with a controlled
environment. These steps should be performed indoors to avoid exposure to
the elements.

3.1 Inserting or Replacing Batteries

You may use AAA Alkaline, AAA Lithium, or AAA NiMH batteries to power the
CAMERA MASK (1.5V AAA, LR03, FR03). NOTE: We suggest using Energizer ®
Lithium batteries to power this product. The battery life is approximately 10 times
longer than alkaline batteries when used in the CAMERA MASK.
NOTE: The LCD indicator shows battery life. When no remaining bars are
displayed, the battery is low. Replace batteries to continue using. Files on either the
internal memory or on the Micro SD card will not be lost if battery power runs out or
during replacement of the batteries.
CAUTION: Always insert two new batteries of the same type and brand. Do not mix
different types of batteries. Follow all instructions from the battery manufacturer of
the batteries that you use.
To insert or replace batteries:
1. Locate the BATTERY COMPARTMENT.
2. Open the BATTERY COMPARTMENT. Remove the cap slowly.
3. Locate and remove the BATTERY PLUG. CAUTION: Do not lose this part. The
CAMERA MASK will not function without this part.
4. Remove and dispose of the old batteries in accordance with local laws.
5. Insert the new batteries in accordance with the Diagram inside the BATTERY
COMPARTMENT on the CAMERA MASK.
6. Reinsert the BATTERY PLUG.
7. Close the BATTERY COMPARTMENT to the water proof range marked on the
mask housing (detail pg5). Do not overtighten cap.
ENG-7