3. Use a soft dry cloth to thoroughly remove all water. Carefully press around the
seams of all compartments to absorb any water left in the cracks.
4. Once the camera is completely dry on the outside, check to make sure that you
are also thoroughly dry including your hands, hair, and clothes before opening any
compartments. This precaution is necessary so that you will not drip water into or
onto the camera.
5. Gently open each compartment. If you find any moisture, sand or debris caught
inside the threads of the outer compartment wall, immediately remove them with a
cloth or cotton swab.
6. If any moisture or debris has accumulated inside a compartment use a cotton
swab to remove it, being careful not to touch the CAMERA MASK electronic
components.
7. Before closing any compartment, replace any loose parts. Then inspect and
clean the inside of the cap prior to positioning over the open compartment.
8. To keep the O-RINGS working properly, wipe sand, salt, or debris away from the
O-RING after use. and apply a thin layer of SILICONE GREASE to the O-RING
before closing compartment. Keep away from Electronic components.
9. Follow the instructions for downloading any files.
10. Store the CAMERA MASK in a dry place away from direct sunlight.
1
11. Keep the CAMERA MASK at normal room temperatures that do not fluctuate
widely. Do not store next to a heater or an air conditioning unit. The extreme
temperatures may damage the CAMERA MASK. Exposure to extreme temperatures
or temperature fluctuations may cause condensation inside the CAMERA MASK
which may damage the device. If you notice condensation, do not use the CAMERA
MASK. Set in a dry area with room temperature until the condensation disappears.
Run a camera test to check its function prior to regular use. Do not use a hair dryer.
12. HUMID CLIMATES - Make sure to only open the camera briefly in Humid
Climates as moisture in the air may be trapped in the inner compartments if the
camera caps are left opened for a period of time. This will result in condensation on
the LENS when the CAMERA MASK is submerged in warm water.
13. Safe Operating Temperature: 0 to 40°C (32 to 104°F) / Safe Storage
Temperature: -20 to 60°C (-4 to 140°F) / Safe Operating Humidity: 30 to 90% (when
no condensation is visible)/ Safe Storage Humidity 10 to 90% (when no
condensation is visible).
ENG-17
Need help?
Do you have a question about the Explorer Series and is the answer not in the manual?