Main Switch; Steering Friction Adjuster; Power Trim And Tilt Switch On Remote Control Or Tiller Handle - Yamaha 90A Owner's Manual

EMU26090

Main switch

The main switch controls the ignition system;
its operation is described below.
" " (off)
●
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
" " (on)
●
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
" " (start)
●
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
EMU26130

Steering friction adjuster

A friction device provides adjustable resis-
tance to the steering mechanism, and can be
" (off) posi-
" (on) posi-
" (start) po-
" (on) position.
set according to operator preference. An ad-
justing screw or bolt is located on the clamp
bracket, on the right (starboard) side of the
through tube end.
To increase resistance, turn the adjuster
clockwise.
To decrease resistance, turn the adjuster
counterclockwise.
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
EMU26143
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 46 and 48.
Components
ZMU03245
" (up) trims the
19