Servo Installation - Part 2; Receiver/Gyro Installation - THUNDER TIGER Raptor 50 V2 kit Manual

17 Servo Installation-Part2
Assembly Tip: Remove all the servo wheels prior to attaching the steel
linkage balls. Make sure all linkages are the correct length.
See Engine-Throttle Control Linkage on page 17.
(1) HSE2612N Self Tapping Screw(M2.6x12).... 8
(2) HMF2-8N Screw(M2x8)................................ 3
(3) HML2 Hex Nut(M2)...................................... 3
(4) BK0075 Linkage Ball.................................... 3
(5) BK0094 Linkage Rod .................................. 1
(6) BK0092 Linkage Rod .................................. 1
(7) BK0086 Ball Link.......................................... 4
51mm

18 Receiver/Gyro Installation

Thunder Tiger recognizes that there are many brands of radios and gyros to choose from. You are encouraged to
seek the advice of experienced helicopter pilots when making this decision.
(1) BE1052 Antenna Tube................... 1
(2) BK0106 Double Side Tape............ 2
Thunder Tiger TG-8000 piezo
gyro is recommended
Pitch Servo
(7) BK0086
(6) BK0092
(3) HML2
(4) BK0075
(1) HSE2612N
(2) HMF2-8N
Throttle Servo
(1) HSE2612N
(2) HMF2-8N
(2) BK0106
(1) BE1052
Mount the Steel Link
Ball at 10.5mm(approx
7/16") from the center
of the servo horn for
the throttle arm.
(3) HML2
(4) BK0075
15
(7) BK0086
(5) BK0094
(1) HSE2612N
On/Off Switch Face Plate
(3) HML2
(4) BK0075
(2) HMF2-8N
75mm
On/Off Switch
Gyro Amplifier
(2) BK0106
Receiver
(2) BK0106
Battery Pack
(2) BK0106