Main Frame Assembly-Part3; Engine Assembly - THUNDER TIGER Raptor 50 V2 kit Manual

7 Main Frame Assembly-Part3

Insert Main Shaft through the shaft bearings making sure that the end with the holes closest to the end is
pointed down. Next, slide main gear assembly into position on the shaft and line up the holes in the main
shaft with the holes in one way clutch shaft of the main gear assembly. Insert the socket head screw and
secure with the lock nut. Next, slide on the mainshaft lock ring on top of the main shaft bearing and secure
with the two set screws. Then slide on the swash plate assembly and attach the elevator and aileron
control linkages to the outside swash plate linkage balls. Next, slide on washout assembly and attach
washout linkage to the inner linkage balls of the swash plate.
(1) BK0616 Socket Screw(M3x20)............1
(2) HMM3Z Lock Nut (M3)........................ 1
(3) HME4-5B Set Screw (M4x5)............... 2
(4) BK0086 Ball Link ................................ 4
(5) BK0092 Linkage Rod ......................... 2
(6) BK0030 Main Shaft Lock Ring............ 1
(7) BK0029 Main Shaft ............................ 1
(8) Wash Out Assembly
(9) BV0092 Swash Plate Assembly...........1
(10) Main Gear Assembly
58mm

8 Engine Assembly

Note: A piston lock (TTR1166P) purchased from your dealer will
make this a much easier task. You must replace the standard
throttle arm w/the extended throttle arm and attach the linkage
ball.
(1) HMC3-10B Socket Screw(M3x10)..... 2
(2) BV0589 Clutch Shoe..........................1
(3) BV0143 Cooling Fan.......................... 1
(4) No.9605 TT PRO-50H(R) Engine.......1
(5) BK0170 Shim.....................................1
(4) BK0086
(5) BK0092
(4) BK0086
(10) Main Gear Assembly
(2) HMM3Z
(1) HMC3-10B
T ighten the engine
nut securely by
grabbing the plastic
fan with a towel.
(7) BK0029
(1) BK0616
(3) BV0143
Add Blue Locktite
(4) No.9605
9
(8) Washout Assembly
(9) BV0092
(3) HME4-5B
(6) BK0030
(1) HMC3-10B
(2) BV0589
(5) BK0170
Linkage Ball to
throttle Arm