Enabling/Disabling Parksense; Service The Parksense® Rear Park Assist System - Dodge Challenger 2014 Owner's Manual

182 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Enabling/Disabling ParkSense®
ParkSense® can be enabled and disabled through the
Customer-Programmable Features section of the EVIC.
The available choices are: OFF, Sound Only, or Sound and
Display. Refer to "Electronic Vehicle Information Center
(EVIC)/Personal Settings (Customer-Programmable Fea-
tures)" in "Understanding Your Instrument Panel" for
further information.
When ParkSense® is disabled, the instrument cluster will
display the "PARK ASSIST SYSTEM OFF" message for
approximately five seconds. Refer to "Electronic Vehicle
Information Center (EVIC)" in "Understanding Your
Instrument Panel" for further information. When the
shift lever is moved to REVERSE and the system is
disabled, the EVIC will display the "PARK ASSIST SYS-
TEM OFF" message for as long as the vehicle is in
REVERSE.
Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the SERVICE PARK
ASSIST SYSTEM message for five seconds. Refer to
"Electronic Vehicle Information Center (EVIC)" in "Un-
derstanding Your Instrument Panel" for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a faulted condition, the EVIC will
display the SERVICE PARK ASSIST SYSTEM or WIPE
OFF REAR SENSORS message for as long as the vehicle
is in REVERSE. Under this condition, ParkSense® will
not operate.
If WIPE OFF REAR SENSORS appears in the Electronic
Vehicle Information Center (EVIC) make sure the rear
fascia/bumper is clean and clear of snow, ice, mud, dirt