Download Print this page
Dynam P-51D Mustang Instruction Manual

Dynam P-51D Mustang Instruction Manual

Hide thumbs Also See for P-51D Mustang:

Advertisement

Quick Links

Wingspan:
Overall Length:
Flying weight:
Servo:
Battery:
Speed Control:
Motor Size:
Charger
:
 

Instruction Manual

47 in (1200mm)
 
41 in (1045mm)
38.8oz (1100 g)
9g 4pcs include
3S 11.1V 2200mAh Li-Po ,20c
30A brushless
850Kv Brushless Outrunner
3-cell Li-Po balancing

Advertisement

loading

Summary of Contents for Dynam P-51D Mustang

  • Page 1: Instruction Manual

    Instruction Manual Wingspan: 47 in (1200mm)   Overall Length: 41 in (1045mm) Flying weight: 38.8oz (1100 g) Servo: 9g 4pcs include Battery: 3S 11.1V 2200mAh Li-Po ,20c Speed Control: 30A brushless Motor Size: 850Kv Brushless Outrunner Charger 3-cell Li-Po balancing  ...
  • Page 4 RTF INCLUDING RTF including: fuselage wing elevator landing gear Vertical stabilizer Push rod Propeller glue decal balance charger LI-Po battery (11.1V 2200mAh 20C) transmitter Adaptor Spinner...
  • Page 5 Apply the foam glue on the joiner of Insert ¢8x406mm glass fiber tube into the left and right landing gear, push left and right wing, and connect the them in the position. wings together. Fix the rear landing gear on fuselage Fix the wing on fuselage with with 1.5mm hexangular screwdriver.
  • Page 6 Insert the pushrod into elevator Repeat the steps for the rudder. quick-controller and tighten the screw(the servo should be in center position). Install the propeller. Connect the aileron servos with Y wires. Put the battery in position. Install spinner with PA2.5*8mm screws.
  • Page 7 STICK OPERATION MODE 1 MODE 2 MOVEMENT THROTTLE RUDDER control plane airplane action movement ELEVATOR control plane movement airplane action AILERONS airplane action Aileron movement airplane action...
  • Page 8 70 75 70 75 1107x3...
  • Page 9 Open the canopy...
  • Page 10 After flight, the battery cool down to ambient temperature before charging. Wire lead shorts can cause fire! If you accidentally short the wires, the battery must be placed in a safe area for observation for approximately 15 minutes. observation...
  • Page 12 Once you have connected the charger to a power source,The red LED will turn on. Connect the Li-Po battery pack to the charger.When the park is full charged.The green LED will turn on.
  • Page 13: Parts List

    Parts List p51d-03 Vertical stabilizer p51d-01 Fuselage p51d-02 wing p51d-04 Elevator p51d-05 canopy p51d-06 spinner p51d-07 Propeller p51d-08 Blade folder p51d-09 Landing gears p51d-10 Brushless Motor DYAT-008 Servo Horn p51d-11 Push rod DYC-1002 Balance Charger p51d-12 Bolt Pipe DY-3001 quick-controller DY-1007 9g Servo DYA-000X Adaptor...