Do you have a question about the Hawker Tempest DY8959 and is the answer not in the manual?
Questions and answers
Trevelly Cuthbert
February 27, 2025
How are the wing LEDs supposed to be connected.
2 comments:
Mr. Anderson
May 14, 2025
For the Dynam DY8959, the wing LEDs should be connected to the main LED controller board located inside the fuselage. Each wing has LED wires that need to be plugged into the corresponding left and right LED ports on the controller. Ensure the polarity is correct—match the positive and negative wires as marked. The LED controller is usually powered through the aircraft's main power system or a dedicated channel from the receiver.
This answer is automatically generated
Bob H
May 23, 2025
@Mr. Anderson Thanks but mine didn't come with a controller. I'll knock one up , there's bound to be a simple circuit on the net.
Need help?
Do you have a question about the Hawker Tempest DY8959 and is the answer not in the manual?
Questions and answers
How are the wing LEDs supposed to be connected.
For the Dynam DY8959, the wing LEDs should be connected to the main LED controller board located inside the fuselage. Each wing has LED wires that need to be plugged into the corresponding left and right LED ports on the controller. Ensure the polarity is correct—match the positive and negative wires as marked. The LED controller is usually powered through the aircraft's main power system or a dedicated channel from the receiver.
This answer is automatically generated
@Mr. Anderson Thanks but mine didn't come with a controller. I'll knock one up , there's bound to be a simple circuit on the net.