Instruction Manual Wingspan: 47 in (1200mm) Overall Length: 41 in (1045mm) Flying weight: 38.8oz (1100 g) Servo: 9g 4pcs include Battery: 3S 11.1V 2200mAh Li-Po ,20c Speed Control: 30A brushless Motor Size: 850Kv Brushless Outrunner Charger : 3-cell Li-Po balancing...
Page 5
RTF INCLUDING RTF including: fuselage wing elevator landing gear Vertical stabilizer Push rod Propeller glue decal balance charger LI-Po battery (11.1V 2200mAh 20C) transmitter Adaptor Spinner...
Page 6
Apply the foam glue on the joiner of Insert ¢8x406mm glass fiber tube into the left and right landing gear, push left and right wing, and connect the them in the position. wings together. Fix the rear landing gear on fuselage Fix the wing on fuselage with with 1.5mm hexangular screwdriver.
Page 7
Insert the pushrod into elevator Repeat the steps for the rudder. quick-controller and tighten the screw(the servo should be in center position). Install the propeller. Connect the aileron servos with Y wires. Put the battery in position. Install spinner with PA2.5*8mm screws.
Page 8
STICK OPERATION MODE 1 MODE 2 MOVEMENT THROTTLE RUDDER control plane airplane action movement ELEVATOR control plane movement airplane action AILERONS airplane action Aileron movement airplane action...