Display Settings - Kenwood KDC-BT765HD Instruction Manual

AUDIO SETTINGS
REAR HPF R - HPF FRQ
R - HPF SLOPE
R - HPF GAIN
SUBWOOFER LPF SW LPF FRQ
SW LPF SLOPE
SW LPF PHASE
SW LPF GAIN
• [SUB-W LEVEL]/ [SUBWOOFER] of [SPEAKER SIZE]/ [SUBWOOFER LPF] of [X ' OVER] is
selectable only if [SUBWOOFER SET] is set to [ON]. ( 22)
• [TWEETER], [REAR HPF] and [SUBWOOFER LPF] of [X ' OVER] is selectable only if a setting
other than [NONE] is selected for [TWEETER], [REAR] and [SUBWOOFER] of [SPEAKER
SIZE]. ( 22)
• Once you have selected the speaker size ([SPEAKER SIZE], 22), the frequency and slope
settings are automatically set for the crossover of the selected speaker.
(Refer FRONT HPF, 22.)
30HZ/ 40HZ/ 50HZ/ 60HZ/ 70HZ/ 80HZ/ 90HZ/
100HZ/ 120HZ/ 150HZ/ 180HZ/ 220HZ/ 250HZ:
Adjusts the crossover frequency for the subwoofer
(low pass filter). ; THROUGH: All signals are sent to
the subwoofer.
–6DB/ –12DB/ –18DB/ –24DB: Adjusts the
crossover slope. (Selectable only if a setting other
than [THROUGH] is selected for [SW LPF FRQ].)
REVERSE (180°)/ NORMAL (0°): Selects the phase
of the subwoofer output to be in line with the
speaker output for optimum performance.
–8 to 0: Adjusts the output volume of the
subwoofer.

DISPLAY SETTINGS

: ZONE 1
: ZONE 2
Set the dimmer
Press and hold DISP (DIM) to turn on or off the dimmer.
• If you have set [DIMMER TIME] ( 24), it will be canceled once you press
and hold this button.
Other settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select [DISPLAY], then press the knob.
3 Turn the volume knob to select an item ( 24), then press the knob.
4 3
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
5
Press and hold to exit.
To return to the previous setting item, press
ALL ZONE
.
ENGLISH
23