MSI MS-6555 Manual page 52

Chapter 3
memory will be used to restore the PC to the previous
state when an "wake up" event occurs.
Power Management/APM
This item is used to select the degree (or type) of power saving and is related
to these modes: Suspend Mode and HDD Power Down. There are three op-
tions for power management:
Min Saving Minimum Power Management. Suspend Mode = 1 Hour.
Max Saving Maximum Power Management. Suspend Mode = 1 Min.
User Define Allows end users to configure each mode separately.
Suspend Type
This setting allows you to select the type of Suspend mode. Setting options:
Stop Grant (saves the state of the entire system to disk and then powers off
the system), PwrOn Suspend (the CPU and core system remain powered on in
a very low-power mode).
Modem Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system. Settings are
3, 4, 5, 7, 9, 10, 11 and NA.
Suspend Time Out
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings are Disabled, 1 Min, 2 Min, 4
Min, 8 Min, 12 Min, 20 Min, 30 Min, 40 Min and 1 Hour.
Power Button Function
This setting determines the function of the power button. When set to Power
Off, the power button works as normal power off button. When set to Suspend,
the computer will enter the suspend/sleep mode if you press the power button.
But if the button is pressed for more than four seconds, the computer is turned
off. Setting options: Power Off, Suspend.
Wake Up On PME, Wake Up On Ring/LAN, USB Wakeup From S3
These fields specify whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected.
Note: To use the function of "Wake Up On Ring" & "Wake Up On LAN",
you need to install a modem/LAN card supporting power on function.
3-20