To Print On Other Media; To Print On Vinyl, Mesh Banner, Backlit Banner (Ff), Or - Oki IP-7900-20 Basic Operation Manual

To print on other media

To print on Vinyl, Mesh banner, Backlit banner (FF), or Solvent printing coated paper
Vinyl
Winding mode
LOOSE winding mode
Supply-side tension bar's size
L (light) size
Printer setting
For glossy vinyl
S E L E C T M E D I A
M E D I A : G l o s s y
Media type: Glossy
Banner
Winding mode
TENSION winding mode
Supply-side tension bar's size
Length conforming with the
media width
Printer setting
S E L E C T M E D I A
M E D I A : B a n n e r
Media type: Banner
# M E D I A B A C K M O D E
> 0 1 : B A C K & F W D
MEDIA BACK MODE: BACK & FWD
# M E D I A A D V M O D E
> 0 1 : B A C K & F W D 1
MEDIA ADV MODE: BACK & FWD1
# S U C T I O N F A N L E V E L
> 0 1 : L O W
SUCTION FAN LEVEL: LOW
54
IP-7900/IP-7700 Basic Operation Guide
LOOSE winding
mode
For matte vinyl
S E L E C T M E D I A
M E D I A : M a t t e
Media type: Matte
TENSION
winding mode
To prevent media jams ...
- You are recommended to set the afterheater temperature to
50°C or less.
- Be sure to install the take-up reel unit.
- Load the media in TENSION winding mode.
- Set the media advance mode to BACK&FWD1
- Set the suction fan to LOW.
Media
Supply-side tension bar
Install an L (light)-size tension bar
at the slack center position.
# M E D I A B A C K M O D E
> 0 1 : B A C K & F W D
MEDIA BACK MODE: BACK & FWD
Media
Supply-side tension bar
Install a tension bar conforming
with the media width.