Installing The Wheels; Removing The Wheels; Installing The Wheel Deflectors - Thule Cadence Instructions Manual

4.4 InstallInG the Wheels

1
A. Press and hold the wheel release button on a wheel.
B. Insert the wheel axle into an axle socket.
(See image 1)
C. Release the wheel release button.
D. Press the wheel fully into the axle socket.
E. Verify that the wheel is securely attached to the
carrier by giving it a sharp pull.
F. Repeat for the other wheel.
G. Using a tire pressure gauge check the air pressure
in each tire. The minimum recommended tire
pressure is 30 psi (2.1 bar) and the maximum is 35
psi (2.5 bar).
H. If air pressure is too low in either one of the tires fill
them up using a bicycle tire pump.
WARNING
Before each journey make sure that
both of the wheels are securely locked
in the carrier axle.

4.5 removInG the Wheels

A. Press and hold the wheel release button on a wheel.
(See image 2)
B. Pull the wheel out of the carrier axle.
C. Repeat for the other wheel.
10
2

4.6 InstallInG the Wheel deflectors

3
4
A. Install wheel deflector on the lower frame in front of
the wheels where there's a hole in the fabric
(See image 3)
B. Align the hole on the wheel deflector to hole on
the frame.
C. Insert bolt from the top through the aligned holes.
(See image 4)
D. Tighten nut securely to the bolt using 10mm wrench
and Phillips screw driver (#3)
E. Repeat for the other side.
51100986 - A