Cycling; Installing The Safety Flag - Thule Cadence Instructions Manual

4.7 cyclInG

4.7.1

InstallIng the safety flag

1
A. Insert the flagpole into the metal or plastic collar on the
safety flag.
B. Insert the flagpole through the sleeve on the left hand
side of the body. (see image 1)
4.7.2 InstallIng the ezhItch
QuIck-Release
A. Verify that the quick release skewer is compatible with
your bicycle.
B. Completely unscrew and remove the quick-release
knob from the quick release skewer.
C. Remove one of the springs from the quick-release skewer.
D. Insert the quick-release skewer through the ezHitch™.
(See image 2)
E. Insert the quick-release skewer into the bicycle axle
from the left side pointing right.
F. Replace the spring back onto the quick-release skewer,
narrow end pointing inwards, towards the bicycle.
G. Close the quick-release lever.
H. Replace and tighten the quick release knob until
thumb tight.
I. Open the quick-release lever. (See image 3)
J. Tighten the quick-release knob another full turn.
K. Close the quick-release lever. (See image 4)
L. Verify that the bicycle wheel is securely attached to
the bicycle by giving it a sharp pull.
51100986 - A
2
3
tM wIth a
4
WARNING
The quick-release knob must be tightened on
the quick-release skewer completely with at
least two screw threads showing past the end
of the quick-release knob to ensure the rear
wheel of the bicycle does not loosen off.
Always make sure that the quick-release is
correctly attached. An incorrectly tensioned
quick-release may lead to accidental loosening
of the rear wheel.
11