Husqvarna HUV4210-G Owner's Manual page 57

(8) Throughout the engine or equipment warranty period stated above, Husqvarna will maintain a supply of warranted
parts sufficient to meet the expected demand for such parts.
(9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be
provided without charge to the owner. Such use will not reduce the warranty obligations of Husqvarna.
(10) Add-on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any
non-exempted add-on or modified parts by the ultimate purchaser will be grounds for disallowing a warranty claims.
Husqvarna will not be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or
modified part. *Husqvarna, its authorized dealers, or a service agency approved by Husqvarna.
ITEMS COVERED BY THIS WARRANTY:
The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from
such warranty coverage if Husqvarna demonstrates that the engine or equipment has been abused, neglected, or
improperly maintained, and that such abuse, neglect, or improper maintenance was the direct cause of the need for
repair or replacement of the part. That notwithstanding, any adjustment of a component that has a factory installed,
and properly operating, adjustment limiting device is still eligible for warranty coverage. The following emission
warranty parts list are covered:
SYSTEMS COVERED
Fuel Metering
Exhaust
Air Induction
Ignition
Positive Crankcase Ventilation (PCV) System
Evaporative System
Misc. Parts
Emission-related parts will vary between vehicles; therefore, certain vehicles may not include all of the listed parts
or may include equivalent parts.
3. EXCLUSIONS:
Excluded from this warranty is damage to a vehicle or component resulting from a cause other than a defect including
unreasonable or unintended strain or use, improper installation of accessories, installation of parts or accessories
that are not original equipment, overloading, accident, alteration, abuse or neglect. This warranty covers only those
failures resulting from defects in material or workmanship.
Transportation expenses for warranty services are also excluded from this warranty.
4. VOIDING OF WARRANTY:
THIS AND ANY OTHER WARRANTY SHALL BE VOID IF THE VEHICLE IS ABUSED OR USED IN AN UNINTENDED
MANNER OR SHOWS INDICATIONS THAT IT HAS BEEN ALTERED IN ANY WAY, INCLUDING, BUT NOT LIMITED
TO, MODIFICATION OF THE SPEED GOVERNOR, BRAKING SYSTEM, STEERING, TRANSAXLE, OR OTHER
OPERATING SYSTEMS OF THE VEHICLE TO CAUSE IT TO PERFORM OUTSIDE HUSQVARNA SPECIFICATIONS.
THE WARRANTY IS LIKEWISE VOID IF THE VEHICLE INVOLVED SHOWS INDICATIONS THAT REASONABLE OR
NECESSARY MAINTENANCE AS OUTLINED IN THE OWNERS MANUAL AND MAINTENANCE AND SERVICE
MANUAL WAS NOT PERFORMED AT THE TIME AND IN THE MANNER SPECIFIED IN SUCH MANUALS.
5. NO CONSEQUENTIAL DAMAGES:
In no event shall Husqvarna be liable for any incidental or consequential damages including, but not limited to, loss
related to property other than the vehicle, loss of use, loss of time, inconvenience, or any other economic loss. This
warranty is applicable only where the California or U.S. EPA emission control system warranty regulation is in effect.
6. HOW TO MAKE A WARRANTY CLAIM:
PARTS DESCRIPTION
Carburetor assembly, fuel injection pump, fuel injection nozzle, fuel
regulator
Catalytic Converter, Exhaust Manifold
Air filter housing, air filter*, crankcase breather tube
Flywheel magneto, ignition pulse generator, ignition coil assembly,
ignition control module, spark plug cap, spark plug*
PCV valve, oil filler cap
Fuel Tank, Fuel Cap, Fuel Lines, Fuel Line Fittings, Clamps, Pressure
Relief Valves, Purge Valves, Vapor Hoses, Carbon Canister, Canister
Mounting Brackets, Carbon Canister Purge Port Connector
Belts, hosing, tubing, fittings, seals, gaskets, clamps, and switches
associated with the above systems
2009 HUV4210 Owner's Manual
Warranties
Page 55