General Information; Front Bumper And Brush Guard - Husqvarna HUV4210-G Owner's Manual

General Information

(Viewed from passenger side of vehicle)
1. Remove negative battery cable.
2. Remove positive battery cable.
Connect battery cables in reverse order.
1
Figure 2 Gasoline Vehicle
GENERAL INFORMATION
This manual features two models: the electric vehicle and the gasoline vehicle. Throughout this manual, important
features unique to each model are highlighted. We urge the owner/operator to read and understand this manual, and
to pay special attention to the features specific to his/her vehicle(s).

FRONT BUMPER AND BRUSH GUARD

The front bumper and brush guard are an important part of the vehicle's design for correct weight distribution. These
parts are interchangeable, but one or the other must be installed at all times during vehicle operation to achieve proper
balance (Figure 4 and Figure 5). See following WARNING.
WARNING
• Do not operate the vehicle without an installed front bumper or brush guard that is specifically
designed and approved for use on this vehicle. Instability in the vehicle could cause serious injury or
death.
Page 12 2009 HUV4210 Owner's Manual
(–)
4
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or connecting
battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
2
Figure 3 IQ System Electric Vehicle
(+)
1
2
3