•
The battery door must be closed and locked before
you operate the Product.
•
Use only cables with correct voltage ratings.
•
Remove all probes, test leads, and accessories
before the battery door is opened.
•
Replace the batteries when the low battery indicator
shows to prevent incorrect measurements.
•
Do not apply more than the rated voltage, between
the terminals or between each terminal and earth
ground.
•
Measure a known voltage first to make sure that the
Product operates correctly.
•
Use the correct terminals, function, and range for
measurements.
•
Do not use test leads if they are damaged. Examine
the test leads for damaged insulation, exposed metal,
or if the wear indicator shows. Check test lead
continuity.
•
Do not touch the probes to a voltage source when
the test leads are connected to the current terminals.
•
Do not use test leads if they are damaged. Examine
the test leads for damaged insulation and measure a
known voltage.
•
Do not use in CAT III or CAT IV environments without
the protective cap installed on test probe. The
protective cap decreases the exposed probe metal to
<4 mm. This decreases the possibility of arc flash
from short circuits.
Symbols
Table 1 is a list of the symbols used on the Product and in this
manual.
Table 1. Symbols
Symbol
Consult user documentation.
W
WARNING. RISK OF DANGER.
WARNING. HAZARDOUS VOLTAGE. Risk of
X
electric shock.
Earth
AC (Alternating Current)
DC (Direct Current)
Both direct and alternating current
True-rms Multimeters
Symbols
Description
3