Advertisement
Step 66 Tail Gear Mesh
Apply a small amount of L262 Red threadlock to the shaft
ahead of the spacer on the tail output shaft and slide one
M5x13 bearing against the spacer. Remove the tail input
shaft and position both the input and output shafts into
the right side of the tail gearbox. Apply a liberal amount
grease to cover the gears.
Tail gear mesh is controlled by the gears. Initially the tail
mesh will be tight until the tail gears wear in.
Grease to be used inside the tail gearbox should be a teflon, light
lithium or silicon type of grease commonly found in a hobbyshop
for R/C cars. Do not use any grease on any other gears.
M3 Locknut
x 3
L
Step 68 Tail Pitch Plate
Apply a small amount of slow cyanoacrylate glue to
the lip on the brass tube and insert into the flat side
of the pitch plate (the molded stand off is flush to the
bearing) and press firmly in place. Apply a small drop
of L262 Red threadlock at the joint of the pitch plate
and the tube and slide one M6x10 ball bearing, fol-
lowed by the pitch plate housing. Slide the second
M6x10 bearing and apply the L262 Red threadlock
with a needle to the joint between the bearing and the
brass tube. Allow the threadlock to cure. Slide the
M6x9x0.35 flat washer and the lock ring to secure the
assembly together. Using slow cyanoacrylate or JB
Weld bond the lock ring to the brass tube.
Extreme care must be taken to avoid damaging the bearing by
leaking adhesive inside. This is not covered by warranty.
#HI6078A Tail
Gearbox Set
M3x15 Socket
M3x20 Socket Cap
Screw (mid bottom)
#CNBB513 M5x13
Ball Bearing
M3x10
Socket Cap
Screw
#CNBB511
M5x11 Ball
Bearing
Cap Screw
(mid top)
#HI3089 Tail
Pitch Ball
Links x 2 &
M2x8 Pin x 2
R
Step 67 Tail Gearbox Assembly
Apply a small amount of L262 Red threadlock
to the end of the tail output shaft and slide one
M5x11 ball bearing in place flush with the gear.
Slide the tail boom into the left half, ensuring
that the hole in the tailboom half engages the
boss in the gearbox. Press the left tail gear box
half to close the gearbox and insert one M3x10,
M3x15 and M3x20 socket cap screws from the
left half. Secure using three M3 locknuts.
Make sure that the tail output shaft is
mounted on the right side of the helicopter.
M6x9x0.35
#CNBB610
Steel Washer
M6x10 Ball
Bearing x 2
#HI6078A Tail
Gearbox Set
Lock
Ring
#HI3087A
Pitch Plate
29
Advertisement
