Advertisement
Step 37 Rear CCPM Arm
Align and press the rear ccpm arm
onto the exposed axle with the arm
pointing to the bottom of the upper
side frames. This is a tight fit, light
tapping with a plastic hammer will
help here. Once the arm is seated,
install the M3x10 button head
screw to secure it in place.
Step 38 Constant Drive Gear Assembly
The constant drive autorotation unit simply slides apart, pull the inner hub assembly up and out from the outer hub. Install
the inner tail gear by aligning the four countersunk holes in the top of the inner gear with the auto hub inserted from below
using four M3x6 flat head screws and L242 Blue threadlock. Tighten the bolts in numbered order. Assemble the main gear
in the same fashion with the main gear installed on top of the autohub, notice there is an alignment groove. Gas SE kits use
an M15x18x0.20 shim between the inner and outer hubs.
4
1
M3x6 Flat Head
Screws x 4
4
1
3
M3x10 Button
Head Screw
#CNLR1014
Short Steel Ball
2
3
#HI6058B Ma-
chined Inner Gear
70T - CT Drive
2
#HI6058M Auto-
hub - Inner Gear
CT Drive
#HI6058N Auto-
hub - Outer Gear
CT Drive
#HI6058H
Machined Main
Gear 88T - CT
Drive
#HI6064D
Gas SE only
M15x18x0.20
Sprague
Shim
#HI6064A
Autohub - Inner
Gear Sprague
CT Drive
#HI6064B
Autohub - Outer
Gear Sprague CT
Drive
4
1
M3x6 Flat Head
4
1
2
3
Screws x 4
2
3
17
Advertisement
