Advertisement
Step 26 Right Front Lower Frames
Starting from the right side of the battery tray, slide
the matching servo frame in place first followed by
two M3x10x8 spacers. Install the fuel tank with the
opening on the left side (the tank only fits one way)
and slide the front lower side frame over the exposed
threaded studs. Insert two M3x8 socket cap screws
through the front side frame and secure with two M3
locknuts on the inside flange of the vertical frame.
Install one M3 locknut on the rearmost stud at the
back of the battery tray, the front stud remains empty
at this time.
Slide the front frame assembly over the landing gear frame and insert four M3x8
socket cap screws through the lower frames into the landing gear frame, do not use
threadlock at this time. Install one M4x10 socket cap screw and M4 flat washer into
the slot in the frame, threaded into the side mounts on the engine crankcase. Do not
used threadlock until after the upper frames are installed.
M3x10x8 Short
Frame Spacers x 2
M3 Locknut
x 2
#HW6115B Front
Lower Frame (Right)
#HI6138A Fuel
Tank Spacer &
M3x8 Socket
Cap Screw
M3x8 Socket
Cap Screws x 4
Step 27 Fuel Tank Spacer
As you will notice the fuel tank will float between the
front lower side frames. Install the M3x10x17 fuel
tank spacer on the right side frame into the center
hole with one M3x8 socket cap screw using L242
Blue threadlock.
Step 28 Front Frame Assembly
Do not threadlock the frame bolts
until the upper frames are installed
as it is critical to have the clutch
and clutch bell assembly align
perfectly. To accomplish the
frames can be shifted within the
limits of the fasteners.
M4x10 Socket
Cap Screws x
2 & M4 Flat
Washer x 2
M3 Locknut
M3x8 Socket
Cap Screws x 2
13
Advertisement
