Advertisement
Step 23 Servo & Front Lower Frame - Left Side
The fuel tank isolators are a "U" profile that need to be fitted
to the fuel tank openings on the lower front side frames. Start
at the center of one edge and work the isolator into the frame,
seating the corners. Towards the end, continue forcing the rub-
ber material until the ends butt against each other. Note that
the frames are different sizes and some trimming is necessary.
Starting from the left side, slide one of the servo side frames
onto the threaded studs on the battery tray, followed by two
M3x10x8 spacers and finally the Left (with smaller fuel tank
opening) front lower frame. Secure using one M3 locknut at
the rearmost stud, do not overtighten as it could loosen the bolt
on the battery tray.
#HW6112
Servo Side
Frame
M3x8 Socket
Cap Screws x 2
Step 25 Fuel Tank Fittings
Assemble the fuel stopper by placing the small brass
tube into the rubber stopper where there is rubber
wall (sealing the fuel system). When connecting the
cap of the stopper make sure the holes DO NOT line
up (further sealing the plug).Tighten the fuel stopper
screw until just prior to compressing the rubber and
insert into tank. Once stopper is in fuel tank finish
tightening the plug screw.
Straight Fit-
ting (1)
12
M3x10x8 Short
Frame Spacers x 2
Battery Tray
Assembly
#HI6138
Fuel Tank
Isolator
#HW6112B
Vertical Frame
(flange rearward)
M3x10 Button
Head Screw x 2 &
M3 Locknut x 2
M3
Locknut x 2
Press the Neoprene fuel line onto the straight fitting before in-
stalling into the tank. After securing the fitting into the tank, bend
the paper clip into a "J" to pull out the line to attach the clunk.
Continue to shorten the inside fuel line until the clunk will move
freely front to back and top to bottom.
Neoprene
Fuel Line
"J" Fitting (2)
M5 Hex
#HI6138B
Nut (4)
Fuel Fitting Set
Align the front frame holes to the vertical frame
(flange goes rearward) and the upper holes of the
vertical frame to the battery tray. Insert two M3x8
socket cap screws from the front lower frame through
the vertical frame and secure using two M3 locknuts.
Insert two M3x8 button head cap screws (for fan
shroud clearance) from the vertical frame side and
secure using two M3 locknuts (locknuts need to be
held with pliers) from under the battery tray.
13mm
36mm
Straight
#HW6138 Fuel
Tank Set
21x25 flat
washer
Tank
Clunk
#HW6112
Servo Side
Frame
M3 Locknut
#HW6115B
Front Lower
Frame
(Left)
Step 24 Vertical Frame
Tank Side
50mm
20mm
15mm
J-Type #1
J #2
Tank Top
J Fitting
To top
of tank
"J" Fitting
Straight
Fitting
#1
#2
Advertisement
