Initial Set-Up And Operation; Operator's Safety Precautions; Operating Controls And Indicators - Stoelting A118 Operator's Manual

3.1 OPERATOR'S SAFETY PRECAUTIONS

SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A. Know the machine. Read and understand the
Operating Instructions.
B. Notice all warning labels on the machine.
C. Wear proper clothing. Avoid loose fitting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
Clean/Off/
On Switch
Owner's Manual #513691
SECTION 3

INITIAL SET-UP AND OPERATION

Diagnostic
Light
Figure 3-1 Controls
3.2 OPERATING CONTROLS AND
INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine.
High voltage will shock, burn or cause death. The
OFF-ON switch must be placed in the OFF position
prior to disassembling for cleaning or servicing. Do
not operate machine with cabinet panels removed.
A. CLEAN-OFF-ON Switch
The CLEAN-OFF-ON switch is used to supply
power to the control circuit. When the switch is in
the OFF (middle) position, power is not supplied
to the control board or refrigeration system. When
the switch is in the ON position, the machine
operates in the freezing mode. When the switch
is in the CLEAN position, all refrigeration stops
and the auger starts rotating. If left in the CLEAN
position, defrost mode begins.
Add Mix
Light
5
WARNING
A118/D118 Model Machines