Replacing Light Bulbs - Toyota 2005 Corolla Owner's Manual

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
D
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
274
'05 Corolla_U (L/O 0409)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact
Toyota dealer.
if
Bulb
Light bulbs
No.
Headlights
9005
(high beam)
Headlights
9006
like the
(low beam)
Parking/front side
marker/front turn 3157A
signal lights
your
Front fog lights 9006
Rear side marker
3157
and stop/tail lights
Rear turn signal
3157A
lights
Back−up lights
921
High mounted
921
stoplight
License plate lights —
Interior light —
2005 COROLLA from Sep. '04 Prod. (OM12891U)
W Type
65
A
55
B
27/8 C
55 B
27/8 D
27/8 C
18 D
18 D
5 D
8 E