Adjusting The Airflow Direction And Strength - Sanyo SAP-KRV91EH Technical & Service Manual

1. Horizontal
To Blow the Air from Side to
To Set the Horizontal Airflow
Direction to One Side
To Blow the Air Up and
Down and Side to Side
When Using the People
Sensor
CAUTION
OI-275-29EG
Adjusting the Airflow Direction and
Strength
The direction of the cooling or heating air can be adjusted. (See page
30.)
The horizontal and vertical airflow can be adjusted by moving the flap
and vertical vanes with the remote control unit.
Do not move the flap with your hands. Confirm that the remote control
unit has been turned on.
Press during operation.
Side The horizontal airflow control flaps start to move.
If airflow control is not performed using the People sensor, the
horizontal airflow control flaps swing within a limited range to direct the
airflow direction.
Press again at the desired air direction.
The horizontal airflow control flaps stop moving.
Press until the swing display appears, and then press
To cancel, press
When the People Sensor is used to control the airflow, pressing
•
on the People sensor stops the horizontal airflow control flaps.
When this button is pressed again, the horizontal airflow control
flaps start moving within a limited range without airflow control.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation
may begin to form around the air vent and drip down.
and .
.
29