Troubleshooting - HP StorageWorks DAT 40i Getting Started Manual

Troubleshooting

The first step in problem-solving is establishing whether the problem lies with the cartridge, the
drive, the host server and its connections, or with the way the system is being operated.
Most modern SCSI host bus adapters locate and display attached devices when the system is
booting up. On Windows systems, if you swap or connect a product when your system is
running, you will need to reboot the system. IA32 systems also usually need to be rebooted.
UNIX systems may have pluggable drivers, which allow drives to be attached to a running
system and detected without rebooting.
If the device is not detected on boot up, there is probably a problem with the physical
hardware: cables, termination, connections, power or the host bus adapter itself. If the device
is displayed during boot up but cannot be found in the operating system, this is more likely to
be a software problem.
• If you encounter a problem during installation and need further clarification, refer to
"Problems encountered during installation" below.
• If a problem arises during testing after you have installed the drive, refer to the symptom-
based section "Testing after installation" on page 39.
• For information about cartridges, refer to "Problems with cartridges" on page 41.
• If you need to replace your drive, refer to "Replacing your tape drive" on page 44.
Many users can use HP Library & Tape Tools to help them diagnose problems.
Problems encountered during installation
Unpacking
Description
Some parts appear to be missing or
damaged.
The screws or mounting hardware are not suitable for the server
Description
Additional parts may be required for
fitting the tape drive into the server.
Further information
Contact your vendor if any parts need replacing.
Further information
The HP StorageWorks DAT internal tape drive will
fit into most servers without the need for additional
hardware other than that originally shipped with
your system. If additional parts are required, or the
original parts have been lost, contact your server
vendor.
Mounting hardware is provided with your tape
drive for mounting in HP ProLiant servers. See "Step
4: Attach mounting hardware" on page 17.
37