Hyundai 2016 Tucson Owner's Manual page 372

V V o o i i c c e e R R e e c c o o g g n n i i t t i i o o n n
Using Voice Recognition
Starting Voice Recognition
Shortly press the key on the
steering wheel remote controller. Say
a command.
If prompt feedback is in [ON], then
the system will say "Please say a
command after the beep (BEEP)"
• If prompt feedback is in [OFF]
mode, then the system will only
prompt you with a BEEP tone.
• To change Prompt Feedback
[On]/[Off], go to
SETUP
[Prompt Feedback]
NOTICE
For proper recognition, say the
command after the voice instruc-
tion and beep tone.
Contact List Best Practices
1) Do not store single-name entries
(e.g., "Bob", "Mom", "Kim", etc.).
Instead, always use full names
(including first and last names) for
all contacts (e.g., use "Jacob
Stevenson" instead of "Dad").
2) Do not use abbreviations (i.e., use
"Lieutenant" instead of "Lt." or
"Sergeant" instead of "Sgt.").
3) Do not use acronyms (i.e., use
"County Finance Department"
instead of "CFD").
4) Do not use special characters
(e.g., "@", "hyphen -", "asterisk *",
"ampersand &").
5) If a name is not recognized from
the contact list, change it to a
more descriptive name (e.g., use
"Grandpa Joseph" instead of "Pa
Joe").
[System]
Skipping Prompt Messages
If prompt feedback is ON, you can
bypass the prompt message by
briefly pressing the key on the
steering wheel controls.
The prompt message is immediately
ended and the beep tone will sound.
After the "beep", say the voice com-
mand.
Re-starting Voice Recognition
While system waits for a command
briefly press the key on the
steering wheel control.
The command wait state is immedi-
ately ended and the beep tone will
sound. After the "beep", say the
voice command.
4
4-109